FRP Cooling Tower Casing

Heat Transfer Equipments Pvt Ltd FRP Cooling towers casing is made of selected grade materials of Fibre Glass Reinforced Plastic and resins. Additional embossing is done for extra strength. FRP casing and basins are designed to withstand severe vibration, high wind load and to resist corrosion. Water basin is completely leak proof, which avoids spillage and seepage of water. It is of deep sump to ensure maximum water level at all times and made of FRP with additional stiffening take care of extra water weight. We manufacture Bottle Shape, Square Shape and Seamless.

FRP Cooling Tower Fill

Honeycomb PVC Fills are used for extended contact area having high heat transfer efficiency. The crossing of air and water streams in close proximity, which creates a diffuesed turbulence conductive to evaporation and efficient heat transfer. A pre-eminent quality and long life fill consists of modular block of PVC honey combs construction to create prolonged contact time of hot air with water for maximum heat transfer. The air pressure drop through the fill is negligible. The fills available in different flute size like 6mm, 12 mm, 19 mm and 1.2 mm thichness.

FRP Cooling Tower Nozzles

General fill consists of Honeycomb PVC Film type splash deck is modules with high resistant to corrosion and highly efficient for heat transfer water distribution system. The hot water is raised by hot water riser and taken inside by a PVC hot water header inside. Branch distribution pipes fitted with Polypropylene Splash cups / non clogging nozzles are connected to hot water heater and uniform water distribution over entire fill is achieved. It is totaly maintenance free distribution.

FRP Cooling Tower Drift Eliminator

To reduce carry out losses through entrainment of moisure drops in the stream by specially designed drift elimiator made of PVC Fills. Additional PVC eliminator is provided in large capacity cooling towers.

FRP Cooling Tower Motor

Special low RPM totally enclosed motors of vertical, Flange type with enlarged and treaded shaft and sealed top is supplied with the cooling tower. The motor is also weather proof and in IP-55 construction.

FRP Cooling Tower Energy Fans

A new generation, state of the art fans, the energy economy concept. Built with uncompromising international quality standards. Our fans are combination of performance, strength, endurance and reliability.

•   Design: Frp fan blades have been specially designed aerodynamically for cooling towers. Flow characteristic of the fan outlet ensures an optimum distribution of air across the cooling tower, giving an added benefit to the system
•   Power Saving: FRP fans are most efficient, consumes upto 30% less power than conventional aluminum alloy / FRP blades. Thus saving in operational cost is enormous.
•   Light Tough and Strong: Due to considerably lower mass of FRP blades, drives and support frames can be made similar and hence cheaper. FRP blades are made by specially adopted technique. These are hollow and light but are extremely fatigue resistant, tough and strong.
•   FRP Cooling Towers Blancing: The hub assemblies are balanced dynamically on computerised machine. The blades are matched movement balanced.
•   FRP Cooling Towers Erosion and chemical Resistance: Fan assembilies provide bvariable pitch angle fan blades for maximum temperature control, continoyus power savings and when needed freeze protection.